How Do You Unstick a Collapsible Fishing Pole?

Collapsible fishing poles are an essential tool of the avid fisherman. Many anglers rely on these poles to help them reach far away spots and make their catches.

But, as with any tool, they can become stuck or not perform correctly over time. While this can be a nuisance for a fisherman who is ready to hit the water, there are a few steps that can be taken to unstick a collapsible fishing pole.

1. Clean and Inspect the Pole:

The first step when trying to unstick a collapsible fishing pole is to clean it off with a damp cloth.

If possible, take apart the sections of the pole and get in between all of the seams and crevices. Once cleaned, inspect the pole for any signs of damage or wear and tear. Look for broken parts or bent pieces that could be causing the issue.

2. Lubricate:

Once you have cleaned and inspected the pole, it is time to lubricate it. There are specific lubricants available for fishing poles, but cooking oil or WD-40 will also do in a pinch. Apply a small amount along each section of the pole and then work it into each joint with your fingers or a cotton swab.

3. Test:

After you have lubricated your fishing pole, it is time to test it out. Start by fully extending each section until you reach maximum extension.

Then collapse the pole back down again slowly and check for any sticking points or other issues that may still be present.

4. Adjustments:

If everything checks out alright upon testing, you may need to make some minor adjustments in order to get your collapsible fishing pole working properly again. This may involve tightening up certain bolts or screws that may have become loose over time.

Unsticking a collapsible fishing pole can take some patience and elbow grease, but with these simple steps you can get yours back up and running again in no time at all!

Conclusion –

How Do You Unstick a Collapsible Fishing Pole?

Unsticking a collapsible fishing pole involves cleaning and inspecting the rod for damage or wear and tear, lubricating all sections of the rod evenly with either specialized lubricant or cooking oil/WD-40, testing out each section after lubrication has been applied, and making necessary adjustments if needed.

Photo of author

Daniel Bennet