How Do You Glue a Fishing Rod Tip?

Fishing rods come in many different shapes and sizes, but one thing they all have in common is the need to be repaired when they become damaged. A broken fishing rod tip is a common problem that can easily be fixed with a bit of glue and some patience. In this article, we’ll explain how to properly glue your fishing rod tip so you can get back to casting in no time.

Step 1: Preparation

Before you begin, make sure you have the following supplies on hand:

  • Fishing rod tip
  • Glue (preferably a strong epoxy)
  • Clamps (to hold the pieces together while drying)
  • Sandpaper

Step 2: Sanding

Once you have everything you need, it’s time to start the repair process. Begin by taking some sandpaper and lightly sanding the broken area of your fishing rod tip.

This will help provide a better surface for the glue to adhere to.

Step 3: Applying Glue

Once you’ve finished sanding, use an adequate amount of glue and spread it over both sides of the break. Make sure that each side has an even coating of glue.

(Be careful not to apply too much glue as this can cause hardening and cracking. )

Step 4: Clamping

Now that you’ve applied your glue, it’s time to clamp the two pieces together. Place a clamp on either side of the break and tighten it securely.

(Make sure not to over-tighten or your fishing rod may become damaged further.)

Step 5: Letting It Dry

At this point, all that’s left is to let the glue dry. Leave your clamps on overnight or until completely dry and then remove them carefully.

(Be sure not to pull apart the pieces too quickly as this could cause them to break again.)


Now that we’ve gone through all the steps necessary for gluing a fishing rod tip back together, we hope that any future repairs are successful! With patience and care, your fishing rod should be good as new in no time!

Conclusion: How Do You Glue a Fishing Rod Tip?


Gluing a fishing rod tip is relatively straightforward – just make sure you have all the supplies on hand before starting.

Begin by lightly sanding both sides of the break before applying an even coat of strong epoxy glue. Then clamp both sides together securely before letting it dry overnight or until completely dry. With patience and care, your fishing rod should be good as new in no time!

Photo of author

Emma Gibson