How Do You Fix a Guide Ring on a Fishing Pole?

The guide rings on a fishing pole are what keep the angler’s line in place. They provide support for the line, so that it won’t rub up against the rod and create friction.

If these guide rings become damaged or come off, the angler will need to take the time to replace them.

In order to fix a guide ring on a fishing pole, first you will need to disassemble the reel. Remove the handle and any other parts that are attached to it.

Take care not to lose any of the small screws or pieces while doing this as they can be difficult to replace.

Next, remove any old guide ring that is still attached to the rod. This might require cutting away some of the old material with scissors or pliers if it has become worn away over time. Be sure not to cut too close to where you don’t want it cut.

Once all of these steps have been completed, you are ready to put in a new guide ring. Measure out how much line you will need for your specific pole and then cut it accordingly with scissors or a knife.

After you have measured and cut the new line, use needle-nose pliers or another tool of your choice to thread it through each of the guide rings until all of them have been replaced.

Finally, reassemble all of the parts that were removed earlier and make sure everything is secure before using your fishing pole again.

Replacing guide rings on a fishing pole can be done easily with just a few simple tools and some patience. With careful attention and practice, anyone can learn how to fix a guide ring on their own fishing pole in no time.

Conclusion: Replacing guide rings on a fishing pole is not difficult if one follows some basic steps such as disassembling the reel, removing any old materials, measuring and cutting new line, threading it through each of the guide rings, and reassembling all of the parts again. With careful attention and practice anyone can learn how to fix a guide ring on their own fishing pole in no time!

Photo of author

Daniel Bennet